Mercedes & Tesla DOIP Adapter
This DoIP Adapter is a new device from Softing Engineering & Solutions GmbH.
This DOIP to OBD Adapter is approved by Mercedes for use with Xentry Pass-thru.
Only For pure DoIP model series (with the introduction of model series 206 and 223)
Also Recommended for Use with The Toolbox software on
Tesla Model 3 October 2023+ ( Asia-Pacific, Europe, Middle East and Africa Regions ), January 2024 + ( North America Region )
Tesla Model S April 2024+ ( All Regions )
Tesla Model X April 2024+ ( All Regions )
Tesla Model Y December 2023+ ( Hong Kong and Singapore Regions ), January 2024+ ( Australia, Japan and Malaysia Regions ), March 2024+ ( South Korea and Thailand Regions ), May 2024+ ( Europe, Middle East and Africa Regions )
Tesla Cybertruck January 2024+ ( All Regions )
PLEASE NOTE: Diagnostic Cables used for These Vehicles should not be plugged into OBD-II J1962 ancillary port which are not DoIP capable.
The Diagnostic Connector for these vehicles can be found in the Drivers Footwell.
- OBD Connector (male)
- 4 pins assigned (RX+, RX-, TX+, TX-)
- RJ45 Ethernet socket 8pin (1:1 connection)
- 75mm size
